There are no cords keeping you in place, so you may move about freely. Moreover, the built-in battery ensures that you remain connected to the world without the need for a regular power source.
But what if your laptop dies due to a power failure? Your laptop is basically useless if it can’t provide you with a good runtime.
As annoying as it may seem, the main culprit is generally a faulty power jack that has halted the power flow. If you have the same problem, keep reading this post to learn how to repair a laptop charging port or jack without a soldering iron.
Table of Contents
Is it Really Possible to Make Things Together Without Soldering? How?
Because not everyone is a “jack of all crafts,” “Without Soldering” is an option. Because the soldering procedure takes accuracy, incredibly steady hands, and a complete understanding of the hardware you’re working on, I’ve said that it’s sensitive.
You may easily cure your problem by following this advice if you bear in mind that any inappropriate or mismanagement might create some form of irreparable harm.
To begin with, you need to determine whether or not your power jack is in fact broken.
When Does A Power Jack Not Work & What Does It Mean?
Basically, a power jack is a little piece of hardware at the bottom of your laptop that lets you plug in a charging pin adaptor for your laptop.
Because the power jack works as a conduit for the flow of energy from the adapter to the laptop battery, I may store electricity for later use. It may malfunction for a variety of reasons, including physical damage or an electrical surge.
The following are some red flags that point to a bad power jack as a potential source of your problems. Your laptop’s charging power adapter may not be working properly, as you may have seen.
P.c: PIXABAY
An increased risk of overheating arises from voltage control failures, which result in excessive heat generation and power loss.
You may have a battery with a charging rate that is too sluggish or that has been incorrectly calibrated. Power jack malfunction may cause a spark or loud noise during charging.
This indicates that there is an electrical risk. Identifying and resolving a problem with your power jack may be a real pain if you see any of these signs.
Easy Steps On How To Fix Laptop Power Jack Without Soldering?
Things you may need:
- Phillips screwdriver
- Bonding Glue
- Anti-static wrist band
- Tape
Let’s have a look at the steps:
Step 1: Turn off your computer and turn it over to see the rear panel.
Step 2: Take out the battery and look for screws.
Step 3: Using the Phillips screwdriver, remove any screws holding the laptop’s body together.
Step 4: Open your laptop’s back panel and remove any unneeded components to access the power connection and motherboard.
Step 5: If the power jack has been moved, make sure it is restored to its original place.
Step 6: Use bonding glue to repair any physical damage to the power jack.
Step 7: If the power jack is metal rather than plastic, connect it to the motherboard using adhesive tape.
Step 8: Close your laptop to check whether the issue has been resolved.
Step 9: If the issue persists, reapply the bonding glue to verify it hasn’t hampered electrical transmission to the motherboard.
Step 10: If your computer has a wired power jack, try loosening it to see if it helps.
Quick Links:
Conclusion: How To Fix Laptop Power Jack Without Soldering?
If your laptop is more than a decade old, you may not have the funds to take it to a repair shop and spend your hard-earned money on it.
That’s why this guide on how to replace a laptop jack without a soldering iron is here to assist you.
